Flush Side Cutters for Electronics
—Flush side cutters trim component leads level with the board rather than leaving a stub, which is what keeps a soldered joint clean and shorts-free.
Specifications
- Flush-cutting jaws for level trims
- Spring return with locking latch
- Hardened steel, sleeved handles
- Sized for component leads and small wire
What you can build with the Flush Side Cutters for Electronics
- Trimming resistor and LED leads after soldering
- Cutting cable ties flush
- Snipping jumper wire to length
- Kit assembly and perfboard work
Compatibility
Used on component leads and light wire only — cutting steel or thick cable will chip the jaws. Not the same as general side cutters, which leave a stub.
Shipping
Dispatched from New Zealand with courier delivery nationwide, including rural addresses. Prices are in New Zealand dollars.
Availability: Sold out
Flush side cutters trim component leads level with the board rather than leaving a stub, which is what keeps a soldered joint clean and shorts-free.
Specifications
- Flush-cutting jaws for level trims
- Spring return with locking latch
- Hardened steel, sleeved handles
- Sized for component leads and small wire
What you can build with the Flush Side Cutters for Electronics
- Trimming resistor and LED leads after soldering
- Cutting cable ties flush
- Snipping jumper wire to length
- Kit assembly and perfboard work
Compatibility
Used on component leads and light wire only — cutting steel or thick cable will chip the jaws. Not the same as general side cutters, which leave a stub.
Shipping
Dispatched from New Zealand with courier delivery nationwide, including rural addresses. Prices are in New Zealand dollars.